Installation Instructions: Tomei Expreme-Ti Titanium Exhaust for the Nissan 370Z (VQ37)

Tomei Expreme-Ti Titanium Exhaust for the Nissan 370Z (VQ37)

Please note that installing the Tomei Expreme-Ti Titanium Exhaust for the Nissan 370Z (VQ37) requires technical expertise and specialized tools. It is highly recommended to have a professional mechanic or exhaust specialist perform the installation. However, if you still wish to proceed with the installation yourself, here is a step-by-step guide:

Tools you’ll need:

• Socket set or wrench
• Jack and jack stands
• Exhaust hangers or rubber isolators (if necessary)
• Penetrating oil or lubricant
• Safety goggles and gloves

STEPS

Step 1: Preparation Ensure that your vehicle is parked on a level surface. Put on safety goggles and gloves to protect yourself during the installation. If needed, use a jack to lift the rear of the vehicle and secure it with jack stands for better access.

Step 2: Removal of the stock exhaust Start at the rear of the vehicle and work your way forward. Begin by loosening and removing any bolts or clamps connecting the sections of the stock exhaust system. Use penetrating oil or lubricant if any bolts are difficult to loosen.

Step 3: Disconnect and remove the stock exhaust Disconnect any hangers or rubber isolators that secure the stock exhaust system to the vehicle. Carefully lower the stock exhaust system from the vehicle, ensuring it does not cause any damage.

Step 4 : Preparing the Tomei Expreme-Ti exhaust Before installing the Tomei Expreme-Ti exhaust, inspect it for any damages or defects.

Steps 5 : Installation of the Tomei Expreme-Ti exhaust Follow these steps for installing the Tomei Expreme-Ti exhaust:

• Start from the rear of the vehicle and work your way forward.
• Position the Tomei Expreme-Ti exhaust in place, aligning it with the mounting points on the vehicle’s chassis.
• Attach the exhaust using the provided hardware, Which are bolts and gaskets.
• Tighten the bolts securely. Be careful not to overtighten them. Which may cause damage to the exhaust or the vehicle’s components.

Step 6: Check fitment and clearance Once the exhaust is securely installed. Double-check its fitment and ensure there is adequate clearance between the exhaust components. Any surrounding parts, Which are the bodywork or suspension components.

Step 7: Lower the vehicle and test If you used a jack and jack stands, carefully lower the vehicle to the ground. Start the vehicle and let it idle for a few moments to check for any leaks, unusual noises, or vibrations. Take the vehicle for a test drive to ensure everything is functioning correctly.

Note: The above steps provide a general guideline for installing the Tomei Expreme-Ti Titanium Exhaust. It’s important to refer to the specific installation instructions provided by Tomei for detailed steps and any specific requirements.